06 intake manifold skunk 2 throttle body

[vonagetsx]

i was wondering if u need an adaptor plate for the 06 tsx intake maifold when using the skunk2 throttle body with it
i have an 04 tsx

[IntegraGSR23]

06 IM is a direct bolt on to the 04/05's. The skunk2 TB's are cable not DBW, you know that right?

[vonagetsx]

na i diddnt know that

[vonagetsx]

what tb would you recommend to go with the 06 IM, i see people using the 06 tb with the 06 manifold.

[xjohnkdoex]

Originally Posted by vonagetsx

what tb would you recommend to go with the 06 IM, i see people using the 06 tb with the 06 manifold.

you just answered your own question. if you really want to increase the diameter further, just big-bore your 06 throttle body somewhere.

[IntegraGSR23]

Originally Posted by vonagetsx

what tb would you recommend to go with the 06 IM, i see people using the 06 tb with the 06 manifold.

Depends on the route you wanna go. Cable or DBW?

I have the 06 TB & IM

[evertp1]

or a TL-S throttle body

[TSX_WS]

Gains from this will be pretty lame, UNLESS u are doing a serious N/A set-up. If u are going k-pro with cams and u have a really thirsty for air set-up, then I would suggest RBC IM from JDM accord euro R and boring your own throttle body to 65-68 MM. Dont get me wrong tho, this 06 IM will make a difference nevertheless

[vonagetsx]

word good looks everyone

[matiasneto]

or you could use the im for the euro civic type r, it is suppose to give the best gain of any k series im

[kuma912]

Originally Posted by matiasneto

or you could use the im for the euro civic type r, it is suppose to give the best gain of any k series im

Theres a good debate on k20a on this. PRC Vs. RRC Vs. RBC

[matiasneto]

ya that is where i read it